Script Commands 305
Stop Physical Disk Blink
This command turns off the indicator light on the physical disk that was
turned on by the start physicalDisk blink command.
Syntax
stop physicalDisk blink
Parameters
None.
Stop Physical Disk Channel Blink
This command turns off the indicator lights on the expansion enclosures that
were turned on by the start physicalDiskChannel blink command.
Syntax
stop physicalDiskChannel blink
Parameters
None.
Stop Physical Disk Channel Fault Isolation Diagnostics
This command stops the physical disk port fault isolation diagnostics, which
stops the start physicalDisk channel fault isolation diagnostics command
before it completes.
Syntax
stop physicalDiskChannel faultDiagnostics
Parameters
None.
NOTE: Use the start physicalDiskChannel faultDiagnostics command and the save
physicalDiskChannel faultDiagnostics command with the stop physicalDiskChannel
faultDiagnostics command. These commands are needed to start the diagnostic
test and save diagnostic test results to a file. You can also stop the start
physicalDiskChannel faultDiagnostics command at any time by pressing <Ctrl><C>.
book.book Page 305 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
Need help?
General