Script Commands 221
Save Physical Disk Log
This command saves the log sense data to a file. Log sense data is maintained
by the storage array for each physical disk.
Syntax
save allPhysicalDisks logFile="filename"
Parameter
Save RAID Controller Module NVSRAM
This command saves a copy of the RAID controller module NVSRAM values
to a file. This command saves all regions.
Syntax
save controller [(0 | 1)] NVSRAM file="filename"
Parameters
Parameter Description
logFile Name of the file to which to write the log sense data. You
must put quotation marks (" ") around the file name.
Parameter Description
controller RAID controller module with the NVSRAM values to save.
Valid RAID controller module identifiers are 0 or 1, where, 0
is the RAID controller module on the left and 1 is the RAID
controller module on the right when viewed from the rear of
the enclosure. You must put brackets ([ ]) around the RAID
controller module identifier.
file Name of the file in which to save the values. You must put
quotation marks (" ") around the file name.
book.book Page 221 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
Need help?
General