302 Script Commands
Parameters
Start Remote Replication Synchronization
NOTE: This command valid only with Fibre Channel storage arrays.
This command starts Remote Replication synchronization.
Syntax
start remoteReplication primary
[”virtualDiskName”] synchronize
Parameter
Start Storage Array Blink
This command identifies a storage array by turning on the indicator LED for
the storage array. Use the stop storageArray blink command to turn off the
indicator LED for the storage array.
Syntax
start storageArray blink
Parameters
None.
Parameter Description
physicalDisk
or
physicalDisks
Identifies the enclosure and slot where the physical disk resides.
Enclosure ID values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID value and slot
ID value.
Parameter Description
primary The name of the primary virtual disk for which you want to start
synchronization. Enclose the primary virtual disk name in double
quotation marks (“ ”) inside square brackets ([ ]).
book.book Page 302 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
Need help?
General