278 Script Commands
Show RAID Controller Module NVSRAM
This command returns a list of the NVSRAM byte values for the specified
host type. If you do not enter the optional parameters, this command returns
a list of all NVSRAM byte values.
Syntax
show (allControllers | controller [(0 | 1)])
NVSRAM [hostType=(hostTypeIndexLabel | host=
"hostName")]
Parameters
NOTE: Use the show controller NVSRAM command to display parts or all of the
NVSRAM before using the set controller command to change NVSRAM values.
Parameter Description
allControllers Returns information about both RAID controller modules in the
storage array.
controller Returns information about a specific RAID controller module in
the storage array. Valid RAID controller module identifiers are 0
or 1, where, 0 is the RAID controller module on the left and 1 is
the RAID controller module on the right when viewed from the
rear of the enclosure. You must put brackets ([ ]) around the
RAID controller module identifier.
hostType Specifies the index label or number of the host type. Use the
show storageArray hostTypeTable command to generate a list of
available host type identifiers.
host Specifies the name of the host connected to the RAID controller
modules. You must put quotation marks (" ") around the
host name.
book.book Page 278 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
Need help?
General