Dell PowerVault MD3620f User Manual

Script Commands 299
Start Physical Disk Channel Fault Isolation Diagnostics
This command runs the physical disk channel fault isolation diagnostics and
stores the results.
Syntax
start physicalDiskChannel [(1 | 2 )]
controller [(0 | 1)] faultDiagnostics
testDevices=[(all | controller=(0 | 1) |
emms=[enclosureID1 (left | right), enclosureID2
(left | right)... enclosureIDn (left |right)] |
physicalDisks= (enclosureID1,slotID1 ...
enclosureIDn,slotIDn)] | (dataPattern=(fixed |
pseudoRandom) |
patternNumber=[(0xhexadecimal | number)] |
maxErrorCount=integer | testIterations=integer |
timeout=timeInterval)
Parameters
Parameter Description
physicalDiskChannel The identifier number of the physical disk channel that
you want to locate. Valid values for the identifier
number are 1 or 2. Enclose the identifier number in
square brackets ([ ]).
controller The identifier letter of the RAID controller module that
you want to test. Valid RAID controller module
identifier values are 0 or 1, where, 0 is the RAID
controller module on the left, and 1 is the RAID
controller module on the right when viewed from the
rear of the enclosure.
testDevices The identifiers of the devices (RAID controller
modules, EMMs, or physical disks) that you want to
test. You can specify all or enter the specific identifiers
for the devices that you want to diagnose.
dataPattern The method of repeatability that you want to test.
book.book Page 299 Wednesday, June 8, 2011 12:20 PM

Dell PowerVault MD3620f Specifications

General

Brand	Dell
Model	PowerVault MD3620f
Category	Storage
Language	English