AH Motion Controller – Operation Manual
9-28
Error code Description
CPU
Status
ERROR
COM2 receives no response from slave 22 by MODBUS.
COM2 receives no response from slave 23 by MODBUS.
COM2 receives no response from slave 24 by MODBUS.
COM2 receives no response from slave 25 by MODBUS.
COM2 receives no response from slave 26 by MODBUS.
COM2 receives no response from slave 27 by MODBUS.
COM2 receives no response from slave 28 by MODBUS.
COM2 receives no response from slave 29 by MODBUS.
COM2 receives no response from slave 30 by MODBUS.
COM2 receives no response from slave 31 by MODBUS.
COM2 receives no response from slave 32 by MODBUS.
9.2.2. Analog I/O Modules and Temperature Measurement Modules
Error code Description
BUS
ERROR
16#A000
The signal received by channel 0 exceeds the range of inputs which can be
received by the hardware.
Blinking
16#A001
The signal received by channel 1 exceeds the range of inputs which can be
received by the hardware.
Blinking
16#A002
The signal received by channel 2 exceeds the range of inputs which can be
received by the hardware.
Blinking
16#A003
The signal received by channel 3 exceeds the range of inputs which can be
received by the hardware.
Blinking
16#A004
The signal received by channel 4 exceeds the range of inputs which can be
received by the hardware.
Blinking
16#A005
The signal received by channel 5 exceeds the range of inputs which can be
received by the hardware.
Blinking
16#A006
The signal received by channel 6 exceeds the range of inputs which can be
received by the hardware.
Blinking
16#A007
The signal received by channel 7 exceeds the range of inputs which can be
received by the hardware.
Blinking
16#A400
The signal received by channel 0 exceeds the range of inputs which can be
received by the hardware.
ON
16#A401
The signal received by channel 1 exceeds the range of inputs which can be
received by the hardware.
ON
To Next Page
Loading...
Need help?
General
