Chapter 9 Troubleshooting
9-33
9.2.6. AH10EN-5A/AH15EN-5A
Error code Description
Error
The IP address of host 1 conflicts with another system on the network.
The IP address of host 2 conflicts with another system on the network.
The initialization of the system fails.
9.2.7. AH10SCM-5A/AH15SCM-5A
9.2.8. AH10DNET-5A
Error code Description
16#A0F0
The node ID of AH10DNET-5A is the same as other node
ID on the network, or exceeds the range.
The red
The green
The red
16#A0F1 No slave is put on the scan list of AH10DNET-5A.
The red
The green
The green
16#A0F2 The working voltage of AH10DNET-5A is low.
The red
The red
The red
16#A0F3 AH10DNET-5A enters the test mode.
The red
The orange
The orange
16#A0F4 The bus of AH10DNET-5A is switched OFF.
The red
The green
The red
16#A0F5
AH10DNET-5A detects that there is no network power
The red
The red
The red
16#A0F6
Something is wrong with the internal memory of
The red
The red
The green
16#A0F7
Something is wrong with the data exchange unit of
The red
The red
The green
16#A0F8 The product ID of AH10DNET-5A is incorrect.
The red
The red
The green
16#A0F9
An error occurs when the data is read from
AH10DNET-5A, or when the data is written into
The red
light blinks.
The red
light is ON.
The red
light is ON.
16#A0FA
The node ID of AH10DNET-5A is the same as that of the
slave set in the scan list.
The red
The green
The red
Error code Description
BUS
ERROR
The setting of the UD Link is incorrect, or the communication fails.
The communication through the communication port is incorrect.
MODBUS communication error