To Next Page

To Previous Page

2. Remove the rear cover from the range and

measure the resistance of the lock motor. If the

meter reads open the motor is defective. If the

meter reads around 2400 Ohms go to step 3.

3. Remove the right-hand bodyside and measure the

resistance between terminals NO and C of the

door switch with the door closed. If the meter

reads infinity the door switch is defective. If the

meter reads zero go to step 4.

4. Measure the resistance between pins 9 and 11 of

the 15 pin plug. If the meter reads infinity the lock

switch is defective. If the meter reads zero

replace the control.

Oven door locks when the oven is programmed

for clean but the oven does not heat:

1. If the oven operates normally in bake, replace the

control.

Lock motor runs continuously:

1. With the door in the unlock position, remove power

from the range. Go to the back of the control and

disconnect the 15 pin plug from the control. With an

Ohmmeter measure the resistance between pins 9

and 10 of the 15 pin plug (not on the EOC). If the

meter reads zero the lock switch or the wiring to the

lock switch is defective. If the meter reads infinity

go to step 2.

2. Depress the arm of the lock switch, and measure

the resistance between pins 9 and 10 of the 15 pin

plug. If the meter reads infinity the lock switch or

the wiring to the lock switch is defective. If the meter

reads zero the control is defective.

Door latch is partly closed with door open, cannot

close door:

1. Program the oven for self-clean, remove the

right-hand side panel and hold the oven door

switch closed, the latch mechanism should rotate

close. After 30 seconds touch clear and the latch

mechanism should rotate open.

Electrolux 30" User Manual

Other manuals for Electrolux 30"