52
EMC Connectrix B Series v6.2 ED-DCX-4S-B Hardware Reference Manual
Log In and Configuration
Connecting an Ethernet cable and opening a Telnet session
Note: Connecting the CP blades to a private network/VLAN is
recommended.
After using a serial connection to configure the IP addresses for the
ED-DCX-4S-B, you can connect the active CP blade to the local area
network (LAN).
By establishing an Ethernet connection, you can complete the
ED-DCX-4S-B configuration using either a serial session, Telnet, or a
management application such as Web Tools or Connectrix Manager
Data Center Edition (CMDCE). To create an Ethernet connection to
the ED-DCX-4S-B, follow these steps.
1. Remove the shipping plug from the Ethernet port on the active
CP blade.
2. Insert one end of an Ethernet cable into the Ethernet port.
3. Connect the other end to an Ethernet 10/100/1000 BaseT LAN.
The ED-DCX-4S-B can be accessed through a remote connection
using any of the management tools, such as Telnet, Web Tools, or
CMDCE.
4. To complete any additional ED-DCX-4S-B configuration
procedures through a Telnet session, log in to the ED-DCX-4S-B
by Telnet, using the admin login. The default password is
password.
To Next Page
Loading...
Need help?
General
