86
EMC Connectrix B Series v6.2 ED-DCX-4S-B Hardware Reference Manual
Removal and Replacement Procedures (RRPs)
Introduction
Repair and replacement of faulty parts on the ED-DCX-4S-B should
be performed by a trained EMC Support representative.
Customer servicing of the ED-DCX-4S-B could result in the voiding
of the warranty or service agreement.
The information in this section is provided for information
purposes only and is not intended to be a “how to” guide for
customer performed maintenance. Not all of the FRUs described in
this chapter are available from EMC. Consult your EMC Support
representative for information concerning which components are
replaceable in the field.
The field replaceable units (FRUs) in the ED-DCX-4S-B can be
removed and replaced without special tools. The ED-DCX-4S-B can
continue operating during many of the FRU replacements if the
conditions specified in the procedure are followed.
The following sections contain FRU removal and replacement
procedures (RRPs).
To Next Page
Loading...
Need help?
General
