EasyManuals Logo
Home>Fuji Xerox>Printer>DocuPrint P365 d

Fuji Xerox DocuPrint P365 d User Manual

Fuji Xerox DocuPrint P365 d
217 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
120 Using the Operator Panel Menus
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
•Port Status
NOTE:
Port Status feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on again.
Values:
Adobe Protocol
Purpose:
To spe c i fy PostSc ript
®
communication protocol. You can configure the Adobe Protocol settings for the wired network.
The change becomes effective after the printer is turned off and then on again.
Values:
System Settings
Use System Settings to configure a variety of printer features.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
•Power Saver Time
Purpose:
To specify the time for transition to Power Saver mode.
Values:
Select 1min (default) for Low Power Timer if your printer shares an electrical circuit with your room lights and you
notice them flickering. Otherwise, select a high value to keep your printer available for frequent use with the minimum
warm-up time.
The printer automatically returns to the standby mode from the Power Saver mode when it receives data from the
computer. You can also change the status of the printer to the standby mode by pressing the (Energy Saver) button on
the operator panel.
Disable Disables the USB port.
Enable
*
Enables the USB port.
Auto Sets the PostScript
®
communications protocol automatically.
Standard Sets the PostScript
®
communications protocol to Standard.
BCP Sets the PostScript
®
communications protocol to BCP.
TBCP* Sets the PostScript
®
communications protocol to TBCP.
Binary Sets the PostScript
®
communications protocol to Binary.
Low Power
Timer
1min
*
Specifies the time taken by the printer to enter Low Power mode after it
finishes a job.
1–60 min
Sleep Timer 1min
*
Specifies the time taken by the printer to enter Sleep mode after it has
entered Low Power mode.
1–60 min

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuPrint P365 d and is the answer not in the manual?

Fuji Xerox DocuPrint P365 d Specifications

General IconGeneral
BrandFuji Xerox
ModelDocuPrint P365 d
CategoryPrinter
LanguageEnglish

Related product manuals