Fuji Xerox DocuPrint P365 d User Manual

170 Troubleshooting
 Jagged Characters
 Banding
Problem Action
The printed result has jagged
characters.
Enable Bitmap Smoothing in the print driver. The following procedure uses the PCL 6
driver as an example.
1 On the Advanced tab, set Bitmap Smoothing under Image Options to On.
If the problem persists, check whether or not the downloaded font you are using is
recommended.
If using a downloaded font, ensure that the font is recommended for the printer, operating
system, and the application being used.
If the problem persists, contact the Fuji Xerox local representative office or an authorized
dealer.
Problem Action
The printed result has banding. Replace the drum cartridge if you have a spare cartridge.
See also:
• "Replacing the Drum Cartridge" on page 189
• "Installing a Drum Cartridge" on page 191
If the problem persists, contact the Fuji Xerox local representative office or an authorized
dealer.
Replace the fusing unit if you have a spare unit.
See also:
• "Replacing the Fusing Unit, Transfer Unit and Retard Roll" on page 192
If the cause of the problem is not located, contact the Fuji Xerox local representative office
or an authorized dealer.
Replace the transfer unit and the retard roll.
See also:
• "Replacing the Fusing Unit, Transfer Unit and Retard Roll" on page 192
If the cause of the problem is not located, contact the Fuji Xerox local representative office
or an authorized dealer.

Fuji Xerox DocuPrint P365 d Specifications

General

Brand	Fuji Xerox
Model	DocuPrint P365 d
Category	Printer
Language	English