Hitachi PXR User Manual

2-25
2.7 Ink concentration control
- Select whether or not the ink concentration is controlled based on results of the viscosity
measurement.
- Select whether or not the Ink concentration confirmation message will be displayed when
the power is turned on.
- Perform these at “stop” state
1 Confirm the IJ printer is “stop” state, and press buttons in order of
Circulation control, Next menu, Circulation environment setup and
Start/Continue in the maintenance menu, and then the Circulation env.
setup screen is displayed.
2 Press either [0: Disable] or [1: Enable].
0 The ink concentration is controlled by the dot count control
without measurement of the ink viscosity.
(Dot count control: Amount of ink which is used for printing
and vaporized makeup ink are automatically refilled.)
1 The ink concentration is controlled based on results of the
viscosity measurement.
Caution 1. The default is [1:Enable]
Caution 2. [1. Enable] can not be selected for some inks.
The dot count control is performed for the inks.

Ink type 001 ( JP-K67 )



Back
Status:XXXXXXXX
X
2011.07.07 12:45Circulation env. setup
0 9 8 7 6 5 4 3 2 1
Decre- Incre-
ment ment
Ink concentration control [ 1](0:disable 1:enable)

Hitachi PXR Specifications

General

Brand	Hitachi
Model	PXR
Category	Printer
Language	English