Table 8-40 MPL XML Tag Descriptions (continued)
XML Tag Name Required Description
<duplexunit>
No This is another optional tag that can be used to specify
whether or not the printer has a duplex unit installed.
The default behavior of the driver is to assume that the
device has a duplex unit installed. If the driver is
unable to communicate with the device it will use this
value if specified.
There are only two options for this element:
<duplexunit>Installed</duplexunit>
<duplexunit>NotInstalled</duplexunit>
If the driver is able to communicate with the printer, the
queries made to the physical device will override this
setting.
<harddisk>
No This is an optional tag to specify whether the printer
has a hard disk drive installed in it or not. By default
the MPL enabled driver assumes that the printer does
not have a hard disk drive installed. The driver will
attempt to get this hard disk drive information from the
device itself it can communicate with it. However the
MPL enabled driver can only communicate with
devices over TCP/IP and some Windows print queues.
This element allows you to tell the driver that the
printer specifically does or does not have a hard disk
drive installed. It is particularly useful for printers using
the <UNCPath> element, where the driver may not be
able to communicate with the device.
There are only two options for this element:
<harddisk>Installed</harddisk>
<harddisk>NotInstalled</harddisk>
If the driver is able to communicate with the printer, the
queries made to the physical device will override this
setting.
<SNMPCommunityName>
No This element sets the SNMP community name. If
unused or a value of Null is used, the default name is
“public”.
</hpuniversalprinting>
Yes Terminates the xml file.
ENWW Manage the HP UPD using HP MPA 149
To Next Page
Loading...
Need help?
General