Introduction
Installing the
HP
3235
This manual provides instructions
for
service-trained personnel to install the
HP 3235 Switch/Test Unit (STU) and Switch/Test
Unit
Extenders. Installation
is
in two parts:
1.
Procedures required
to
set-up the STU system and begin using the
HP
3235
User Training Guide.
2.
Procedures
that
are application dependent and follow initial set-up, training,
and familiarization with the
STU system.
Following
is
a summary
of
the procedures contained in each
part
• Set the power requirements on the mainframe (line voltage, fuse,
etc.).
NOTE: Extender frames are not required
for
training.
• Set the frame address
to
zero on the mainframe.
• Connect
the
HP-IB interface from mainframe
to
your system controller.
• Connect the optional control panel (if you have one)
to
the mainframe.
• Install plug-in modules in the mainframe and record the slot number
they
are installed
in.
• Apply power
to
the mainframe.
After completing the installation procedures
of
Part
1,
the system
is
now set up
for
you
to
begin
the
training lessons
in
the User Training Guide (HP
P/N
03235-90006). When finished with the training lessons, you will have an under-
standing
of
the
STU and plug-in module operation.
At
this time, you define
the
test requirement/STU system cabling and proceed with the installation
procedures
of
Part
2.
Part
luslallalion
procedm·es
thai
are application dependent.
• Floating user side ground.
• Installing extender frames if part
of
the system.
• Installing a Bus Access module (mainframe only system).
• Installing Extender modules and digital extender cables (mainframe with
extender frame system).
• Installing analog bus extender cables.
• Installing feedthrough panels.
• Terminal block preparation and connection
of
field wiring.
• Connecting terminal blocks
to
modules.
• Installing
the
optional quick interconnect fixture.
• Rack mounting mainframes
or
extenders.
• Rack mounting the optional control panel.
Installing the
HP
3235
1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General