HP A5830 Series Command Reference

111
[Sysname] stp mode pvst
[Sysname] display stp vlan 2 tc slot 1
-------------- STP slot 1 TC or TCN count -------------
VLAN Port Receive Send
2 GigabitEthernet1/0/1 6 4
2 GigabitEthernet1/0/2 0 2
Table 32 Command output
Field
Description
Port
Port name
Receive
Number of TC/TCN BPDUs received on each port
Send
Number of TC/TCN BPDUs sent by each port
instance
Description
Use the instance command to map a list of VLANs to the specified MSTI.
Use the undo instance command to remap the specified VLAN or all VLANs to the CIST (MSTI 0).
By default, all VLANs are mapped to the CIST.
If you specify no VLAN in the undo instance command, all VLANs mapped to the specified MSTI will be
remapped to the CIST.
You cannot map the same VLAN to different MSTIs. If you map a VLAN that has been mapped to an
MSTI to a new MSTI, the old mapping will be automatically removed.
In PVST mode, you can map multiple VLANs to the CIST, and only one VLAN to each remaining MSTI.
After configuring this command, run the active region-configuration command to activate the VLAN-to-
instance mapping.
Related commands: display stp region-configuration, check region-configuration, and active region-
configuration.
Syntax
instance instance-id vlan vlan-list
undo instance instance-id [ vlan vlan-list ]
View
MST region view
Default level
2: System level
Parameters
instance-id: Specifies an MSTI ID. The minimum value is 0, representing the CIST:
In MSTP mode, the instance-id parameter is in the range of 0 to 31.
In PVST mode, the instance-id parameter is in the range of 0 to 128.

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English