210
LLDP configuration commands
Both bridge mode (Layer 2) and route mode (Layer 3) Ethernet ports support LLDP. The term interface in
this chapter collectively refers to these two types of ports. You can use the port link-mode command to set
an Ethernet port to operate in bridge or route mode (see Layer 2—LAN Switching Configuration Guide).
display lldp local-information
Description
Use the display lldp local-information command to display the LLDP information to be sent, which will be
contained in the LLDP TLVs and sent to neighbor devices.
If no keyword or parameter is specified, this command displays all LLDP information to be sent, including
the global LLDP information and the LLDP information about the LLDP-enabled ports in the up state.
Syntax
display lldp local-information [ global | interface interface-type interface-number ] [ | { begin | exclude
| include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
global: Displays the global LLDP information to be sent.
interface interface-type interface-number: Displays the LLDP information to be sent out the interface
specified by its type and number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Example
# Display all LLDP information to be sent.
<Sysname> display lldp local-information
Global LLDP local-information:
Chassis ID : 00e0-fc00-5600
System name : Sysname
System description : HP Comware Platform Software
System capabilities supported : Bridge,Router
To Next Page
Loading...
Need help?
General