HP A5830 Series Command Reference

1
Ethernet interface configuration commands
General Ethernet interface configuration commands
default
Description
Use the default command to restore the default settings for an Ethernet interface.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. You can use the display this command in interface view to check
for these commands, and perform their undo forms or follow the command reference to individually
restore their default settings. If your restoration attempt still fails, follow the error message to resolve the
problem.
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully
aware of the impacts of this command when you perform it on a live network.
Syntax
default
View
Ethernet interface view
Default level
2: System level
Parameters
None
Example
# Restore the default settings for interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] default
This command will restore the default settings. Continue? [Y/N]:y
description
Description
Use the description command to change the description of the interface.
Use the undo description command to restore the default.

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English