HP A5830 Series Command Reference

24
Syntax
shutdown
undo shutdown
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Examples
# Shut down and then bring up GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] shutdown
[Sysname-GigabitEthernet1/0/1] undo shutdown
# Shut down all member ports in the port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] shutdown
speed
Description
Use the speed command to set the speed of an Ethernet interface.
Use the undo speed command to restore the default.
By default, an Ethernet interface automatically negotiates a speed with the peer.
For an Ethernet copper port, use the speed command to set its speed to match the speed of the peer
interface.
For a fiber port, use the speed command to set its speed to match the rate of a pluggable transceiver.
Related commands: duplex and speed auto.
NOTE:
A Gigabit fiber port does not support the 10 or 10000 parameter. A 10-Gigabit fiber port
does not support the 10 or 100 parameter.
Syntax
speed { 10 | 100 | 1000 | 10000 | auto }
undo speed
View
Ethernet interface view

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English