227
lldp management-address-format string
Description
Use the lldp management-address-format string command to encapsulate the management address in
the form of strings in TLVs.
Use the undo lldp management-address-format command to restore the default.
By default, the management address is encapsulated in the form of numbers in TLVs.
Syntax
lldp management-address-format string
undo lldp management-address-format
View
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Example
# Configure GigabitEthernet 1/0/1 to encapsulate the management address in the form of strings in
management address TLVs.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp management-address-format string
lldp management-address-tlv
Description
Use the lldp management-address-tlv command to enable management address advertising and set the
management address.
Use the undo lldp management-address-tlv command to disable management address advertising in
LLDPDUs.
By default, the management address is advertised through LLDPDUs. For a Layer 2 Ethernet port, the
management address is the main IP address of the lowest-ID VLAN carried on the port. If none of the
carried VLANs is assigned an IP address, no management address will be advertised. For a Layer 3
Ethernet port, the management address is its own IP address. If no IP address is configured for the Layer 3
Ethernet port, no management address will be advertised.
An LLDPDU carries only one management address TLV. If you set the management address repeatedly, the
latest one takes effect.
In Layer 2 Ethernet interface view, if you run the lldp management-address-tlv command without
specifying the ip-address parameter, the advertised management address is the main IP address of the
lowest-ID VLAN carried on the interface. If none of the carried VLANs is assigned an IP address, no
management address will be advertised.
To Next Page
Loading...
Need help?
General