73
display link-aggregation verbose
Description
Use the display link-aggregation verbose command to display detailed information about the
aggregation groups corresponding to the aggregate interfaces.
Use the display link-aggregation verbose bridge-aggregation interface-number command to display
information about a specific Layer 2 aggregation group.
Use the display link-aggregation verbose bridge-aggregation command to display information about all
Layer 2 aggregation groups,.
Use the display link-aggregation verbose command to display information about all aggregation groups.
The bridge-aggregation parameter is available only when you create Layer 2 aggregate interfaces on the
device.
Syntax
display link-aggregation verbose [ bridge-aggregation [ interface-number ] ] [ | { begin | exclude |
include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
bridge-aggregation: Displays detailed information about the Layer 2 aggregation groups corresponding
to Layer 2 aggregate interfaces.
interface-number: Specifies an existing aggregate interface number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Examples
# Display detailed information about the aggregation group corresponding to Layer 2 aggregate
interface Bridge-Aggregation 10, which is a dynamic aggregation group.
<Sysname> display link-aggregation verbose bridge-aggregation 10
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected
To Next Page
Loading...
Need help?
General