18
Parameter
interval: Sets the statistics polling interval, in seconds. It ranges from 5 to 300 and must be a multiple of
5.
Example
# Set the statistics polling interval to 100 seconds on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] flow-interval 100
interface
Description
Use the interface command to enter interface view.
Syntax
interface interface-type interface-number
View
System view
Default level
2: System level
Parameter
interface-type interface-number: Specifies an interface type and number.
Example
# Enter GigabitEthernet 1/0/1 interface view (assuming that the interface is an Ethernet interface).
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1]
jumboframe enable
Description
Use the jumboframe enable command to allow jumbo frames within the specified length to pass through
one or multiple Ethernet interfaces.
Use the undo jumboframe enable command to prevent jumbo frames from passing through one or
multiple Ethernet interfaces.
By default, the switch allows jumbo frames within 9216 bytes to pass through Ethernet interfaces.
In Ethernet interface view, the command applies only to the current Ethernet interface.
In port group view, the command applies to every Ethernet interface in the port group.
Syntax
jumboframe enable [ value ]
undo jumboframe enable
To Next Page
Loading...
Need help?
General