HP A5830 Series Command Reference

224
lldp check-change-interval
Description
Use the lldp check-change-interval command to enable LLDP polling and set the polling interval.
Use the undo lldp check-change-interval command to restore the default.
By default, LLDP polling is disabled.
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
View
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default level
2: System level
Parameter
interval: Sets the LLDP polling interval, ranging from 1 to 30 seconds.
Example
# Enable LLDP polling on GigabitEthernet 1/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp check-change-interval 30
lldp enable
Description
Use the lldp enable command to enable LLDP.
Use the undo lldp enable command to disable LLDP.
By default, LLDP is enabled on a port and globally.
LLDP takes effect on a port only when LLDP is enabled both globally and on the port.
Syntax
lldp enable
undo lldp enable
View
System view, Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default level
2: System level
Parameters
None

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English