78
Parameter
system-priority: Specifies the LACP priority of the local system, in the range of 0 to 65,535. The smaller
the value, the higher the system LACP priority.
Example
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64
link-aggregation lacp traffic-redirect-notification enable
Description
Use the link-aggregation lacp traffic-redirect-notification enable command to enable link-aggregation
traffic redirection.
Use the undo link-aggregation lacp traffic-redirect-notification enable command to disable link-
aggregation traffic redirection.
By default, link-aggregation traffic redirection is disabled.
Link-aggregation traffic redirection applies only to dynamic link aggregation groups.
To prevent traffic interruption, enable link-aggregation traffic redirection on devices at both ends of the
aggregate link.
Do not enable both MSTP and link-aggregation traffic redirection at the same time, because light packet
loss may occur when the device reboots.
Syntax
link-aggregation lacp traffic-redirect-notification enable
undo link-aggregation lacp traffic-redirect-notification enable
View
System view
Default level
2: System level
Parameters
None
Example
# Enable link-aggregation traffic redirection.
<Sysname> system-view
[Sysname] link-aggregation lacp traffic-redirect-notification enable
link-aggregation load-sharing mode
Description
Use the link-aggregation load-sharing mode command to configure the global or group-specific link-
aggregation load sharing criteria.
To Next Page
Loading...
Need help?
General