190
Example
# Display GARP statistics on ports GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2.
<Sysname> display garp statistics interface gigabitethernet 1/0/1 to gigabitethernet
1/0/2
GARP statistics on port GigabitEthernet1/0/1
Number of GVRP Frames Received : 5
Number of GVRP Frames Transmitted : 2
Number of Frames Discarded : 1
GARP statistics on port GigabitEthernet1/0/2
Number of GVRP Frames Received : 3
Number of GVRP Frames Transmitted : 4
Number of Frames Discarded : 2
display garp timer
Description
Use the display garp timer command to display GARP timers on specific ports. If no ports are specified,
this command displays the GARP timers on all ports.
Related commands: garp timer hold, garp timer join, garp timer leave, and garp timer leaveall.
Syntax
display garp timer [ interface interface-list ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface interface-list: Displays the GARP timer settings of one or multiple ports. You can specify up to 10
port lists:
You can specify a single port in the form of interface-type interface-number.
You can specify a port range in the form of interface-type interface-number1 to interface-type
interface-number2, where the end port number specified by interface-number2 must be greater than
the start port number specified by interface-number1.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
To Next Page
Loading...
Need help?
General