231
If the LLDPDU transmit interval is less than the LLDPDU transmit delay, the device uses the LLDPDUs
transmit delay as the transmit interval.
Related commands: lldp timer tx-delay.
Syntax
lldp timer tx-interval interval
undo lldp timer tx-interval
View
System view
Default level
2: System level
Parameter
interval: Sets the LLDPDU transmit interval, ranging from 5 to 32,768 seconds.
Example
# Set the LLDPDU transmit interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20
lldp tlv-enable
Description
Use the lldp tlv-enable command to configure the types of advertisable TLVs for a port or all ports in a
port group.
Use the undo lldp tlv-enable command to disable the advertising of specific types of TLVs.
By default, the device can advertise on a Layer 2 Ethernet port all types of LLDP TLVs, except location
identification TLVs, and advertise on a Layer 3 Ethernet port all types of LLDP TLVs, except IEEE 802.1
organizationally specific TLVs, network policy TLVs, and location identification TLVs.
To enable the device to advertise LLDP-MED TLVs, you must first enable it to advertise LLDP-MED
capabilities TLVs.
To disable the device from advertising LLDP-MED capabilities TLVs, you must first disable it from
advertising other LLDP-MED TLVs.
To disable the device from advertising MAC/PHY configuration/status TLVs, you must first disable it from
advertising LLDP-MED capabilities TLVs.
If you enable the device to advertise LLDP-MED capabilities TLVs, you also enable it to advertise
MAC/PHY configuration/status TLVs.
To enable the device to advertise multiple types of TLVs, you can execute the lldp tlv-enable command
repeatedly without the all parameter specified.
Syntax
In Layer 2 Ethernet interface view or port group view:
lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description | system-name
} | dot1-tlv { all | port-vlan-id | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] } | dot3-tlv { all |
To Next Page
Loading...
Need help?
General