112
vlan vlan-list: Specifies a VLAN list in the format of vlan-list = { vlan-id [ to vlan-id ] }&<1-10>, where the
vlan-id parameter represents the VLAN ID, in the range of 1 to 4094, and &<1-10> indicates that you can
specify up to 10 VLAN IDs or VLAN ID ranges.
Example
# Map VLAN 2 to MSTI 1.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2
region-name
Description
Use the region-name command to configure the MST region name.
Use the undo region-name command to restore the default MST region name.
By default, the MST region name of a device is its MAC address.
The MST region name, the VLAN-to-instance mapping table, and the MSTP revision level of a device
determine the device's MST region.
After configuring this command, run the active region-configuration command to activate the configured
MST region name.
Related commands: instance, revision-level, vlan-mapping modulo, display stp region-configuration,
check region-configuration, and active region-configuration.
Syntax
region-name name
undo region-name
View
MST region view
Default level
2: System level
Parameter
name: Specifies the MST region name, a string of 1 to 32 characters.
Example
# Set the MST region name of the device to hello.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello
reset stp
Description
Use the reset stp command to clear the MSTP statistics information.
To Next Page
Loading...
Need help?
General