To Next Page

To Previous Page

128

Examples

# In MSTP mode, set the priority of port GigabitEthernet 1/0/3 to 16 in MSTI 2.

<Sysname> system-view

[Sysname] interface gigabitethernet 1/0/3

[Sysname-GigabitEthernet1/0/3] stp instance 2 port priority 16

# In PVST mode, set the priority of port GigabitEthernet 1/0/3 to 16 in VLAN 2.

<Sysname> system-view

[Sysname] stp mode pvst

[Sysname] interface gigabitethernet 1/0/3

[Sysname-GigabitEthernet1/0/3] stp vlan 2 port priority 16

stp port-log

Description

Use the stp port-log command to enable output of port state transition information for the specified MSTI

or all MSTIs.

Use the undo stp port-log command to disable output of port state transition information for the specified

MSTI or all MSTIs.

By default, this function is enabled.

Syntax

stp port-log { instance { instance-id | all } | vlan vlan-list }

undo stp port-log { instance { instance-id | all } | vlan vlan-list }

View

System view

Default level

2: System level

Parameters

instance instance-id: Specifies an MSTI. The value of instance-id is in the range of 0 to 31, where 0

represents the CIST. To enable or disable output of port state transition information in STP/RSTP mode,

specify instance 0.

all: Specifies all MSTIs.

vlan vlan-list: Specifies a VLAN list in the format of vlan-list = { vlan-id [ to vlan-id ] }&<1-10>, where the

vlan-id parameter represents the VLAN ID, in the range of 1 to 4094, and &<1-10> indicates that you can

specify up to 10 VLAN IDs or VLAN ID ranges.

Examples

# In MSTP mode, enable output of port state transition information for MSTI 2.

<Sysname> system-view

[Sysname] stp port-log instance 2

%Aug 16 00:49:41:856 2006 Sysname MSTP/3/MSTP_DISCARDING: Instance 2's

GigabitEthernet1/0/1 has been set to discarding state!

HP A5830 Series Command Reference

Other manuals for HP A5830 Series