HP A5830 Series Command Reference

33
<Sysname> system-view
[Sysname] loopback-detection enable
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] loopback-detection enable
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] loopback-detection per-vlan enable
mdi
Description
Use the mdi command to configure the MDI mode of a copper Ethernet interface.
Use the undo mdi command to restore the default.
By default, Ethernet interfaces operate in auto MDI mode.
This command is not applicable to fiber ports.
Syntax
mdi { across | auto | normal }
undo mdi
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
across: Sets the MDI mode to across. In this mode, pins 1 and 2 of the port are receive pins, and pins 3
and 6 are transmit pins.
auto: Sets the MDI mode to auto. In this mode, the port negotiates pin roles with its peer.
normal: Sets the MDI mode to normal. In normal mode, pins 1 and 2 of the port are transmit pins, and
pins 3 and 6 are receive pins.
Example
# Set GigabitEthernet 1/0/1 to operate in across MDI mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mdi across
multicast-suppression
Description
Use the multicast-suppression command to set the multicast suppression threshold on one or multiple
Ethernet interfaces.
Use the undo multicast-suppression command to restore the default.
By default, Ethernet interfaces do not suppress multicast traffic.

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English