85
Port isolation configuration commands
display port-isolate group
Description
Use the display port-isolate group command to display information about one or all isolation groups.
Syntax
display port-isolate group [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Example
# On a single-isolation-group device, display information about the isolation group.
<Sysname> display port-isolate group
Port-isolate group information:
Uplink port support: NO
Group ID: 1
Group members:
GigabitEthernet1/0/2
Table 21 Command output
Port-isolate group information
Display the information of a port-isolation group
Indicates whether the uplink port is supported
Isolated ports (non-uplink ports) in the isolation group
To Next Page
Loading...
Need help?
General