28
Examples
# Display the names of all port groups.
<Sysname> display port-group manual
The following manual port group exist(s):
group1 group2
# Display detailed information about all port groups.
<Sysname> display port-group manual all
Member of group1:
GigabitEthernet1/0/3 GigabitEthernet1/0/4 GigabitEthernet1/0/5
GigabitEthernet1/0/6 GigabitEthernet1/0/7
Member of group2:
None
# Display detailed information about the port group named group1.
<Sysname> display port-group manual name group1
Member of group1:
GigabitEthernet1/0/3 GigabitEthernet1/0/4 GigabitEthernet1/0/5
GigabitEthernet1/0/6 GigabitEthernet1/0/7
group-member
Description
Use the group-member command to assign Layer 2 Ethernet interfaces to a port group.
Use the undo group-member command to remove Layer 2 Ethernet interfaces from the port group.
By default, a port group does not contain any member ports.
If you use the group-member interface-type interface-start-number to interface-type interface-end-number
command to add multiple ports in batch to the specified port group, make sure that the interface-end-
number parameter must be greater than the interface-start-number parameter.
Syntax
group-member interface-list
undo group-member interface-list
View
Port group view
Default level
2: System level
Parameter
interface-list: Specifies an Ethernet interface list, in the form of interface-type interface-number [ to
interface-type interface-number ] &<1-10>, where &<1-10> indicates that you can specify up to 10
interfaces or interface ranges.
Example
# Assign Layer 2 Ethernet interface GigabitEthernet 1/0/1 to the port group named group1.
<Sysname> system-view
To Next Page
Loading...
Need help?
General