25
Default level
2: System level
Parameters
10: Sets the interface speed to 10 Mbps. This parameter is not applicable to GE and 10-GE fiber ports.
100: Sets the interface speed to 100 Mbps. This parameter is not applicable to 10-GE fiber ports.
1000: Sets the interface speed to 1000 Mbps.
10000: Sets the interface speed to 10,000 Mbps. This parameter is not applicable to GE fiber ports.
auto: Enables the interface to negotiate a speed with its peer.
Example
# Configure GigabitEthernet 1/0/1 to operate at 100 Mbps.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] speed 100
Layer 2 Ethernet interface configuration commands
broadcast-suppression
Description
Use the broadcast-suppression command to set the broadcast suppression threshold on one or multiple
Ethernet interfaces.
Use the undo broadcast-suppression command to restore the default.
By default, Ethernet interfaces do not suppress broadcast traffic.
If you execute this command in Ethernet interface view, the configuration takes effect only on the interface.
If you execute this command in port group view, the configuration takes effect on all ports in the port
group.
When broadcast traffic exceeds the broadcast suppression threshold, the system discards broadcast
packets until the broadcast traffic drops below the threshold.
If you set different broadcast suppression thresholds in Ethernet interface view or port group view multiple
times, the one configured last takes effect.
Syntax
broadcast-suppression { ratio | pps max-pps | kbps max-kbps }
undo broadcast-suppression
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
To Next Page
Loading...
Need help?
General