138
undo stp timer-factor
View
System view
Default level
2: System level
Parameter
factor: Sets the timeout factor, in the range of 1 to 20.
Example
# Set the timeout factor of the device to 7.
<Sysname> system-view
[Sysname] stp timer-factor 7
stp transmit-limit
Description
Use the stp transmit-limit command to set the maximum number of BPDUs that the ports can send within
each hello time.
Use the undo stp transmit-limit command to restore the default.
By default, the maximum transmission rate of all ports is 10. Each port can send up to 10 BPDUs within
each hello time.
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
A larger maximum transmission rate value requires more system resources. An appropriate maximum
transmission rate setting can prevent spanning tree protocols from using excessive bandwidth resources
during network topology changes. HP recommends that you use the default value.
Syntax
stp transmit-limit limit
undo stp transmit-limit
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameter
limit: Sets the maximum number of BPDUs the ports can send within each hello time, in the range of 1 to
255.
To Next Page
Loading...
Need help?
General