HP A5830 Series Command Reference

228
In Layer 3 Ethernet interface view, if you run the lldp management-address-tlv command without
specifying the ip-address parameter, the advertised management address is the IP address of the Layer 3
Ethernet port. If no IP address is configured for the port, no management address will be advertised.
Syntax
lldp management-address-tlv [ ip-address ]
undo lldp management-address-tlv
View
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default level
2: System level
Parameter
ip-address: Specifies a management address to be advertised in LLDPDUs.
Example
# Set the management address to 192.6.0.1 for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp management-address-tlv 192.6.0.1
lldp notification remote-change enable
Description
Use the lldp notification remote-change enable command to enable LLDP trapping for a port or all ports
in a port group.
Use the undo lldp notification remote-change enable command to restore the default.
By default, LLDP trapping is disabled on ports.
Syntax
lldp notification remote-change enable
undo lldp notification remote-change enable
View
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Example
# Enable LLDP trapping for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English