158
HP recommends that you set the same PVID for the local and remote hybrid ports.
You must use the port hybrid vlan command to configure the hybrid port to allow and forward packets
from the PVID.
Related commands: port link-type and port hybrid vlan.
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameter
vlan-id: Specifies a VLAN ID, in the range of 1 to 4094.
Examples
# Configure VLAN 100 as the PVID of the hybrid port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] vlan 100
[Sysname-vlan100] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type hybrid
[Sysname-GigabitEthernet1/0/1] port hybrid pvid vlan 100
# Configure VLAN 100 as the PVID of the hybrid Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid pvid vlan 100
port hybrid vlan
Description
Use the port hybrid vlan command to assign the hybrid ports to the specified VLANs.
Use the undo port hybrid vlan command to remove the hybrid ports from the specified VLANs.
By default, a hybrid port only allows packets from VLAN 1 to pass through untagged.
A hybrid port can carry multiple VLANs. If you execute the port hybrid vlan command multiple times, the
VLANs the hybrid port carries are the set of VLANs specified by vlan-id-list in each execution.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports:
To Next Page
Loading...
Need help?
General