HP FlexNetwork 5130 HI series User Manual

93
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
When LACP is operating in passive mode on a local member port and its peer port, both ports cannot
send LACPDUs. When LACP is operating in active mode on either end of a link, both ports can send
LACPDUs.
This command takes effect only on member ports of dynamic aggregation groups.
Examples
# Configure LACP to operate in passive mode on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lacp mode passive
lacp period short
Use lacp period short to set the short LACP timeout interval (3 seconds) on an interface.
Use undo lacp period to restore the default.
Syntax
lacp period short
undo lacp period
Default
The LACP timeout interval is the long timeout interval (90 seconds) on an interface.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Examples
# Set the short LACP timeout interval (3 seconds) on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lacp period short
lacp system-priority
Use lacp system-priority to set the system LACP priority.
Use undo lacp system-priority to restore the default.
Syntax
lacp system-priority system-priority
undo lacp system-priority

HP FlexNetwork 5130 HI series Specifications

General

Model	HP FlexNetwork 5130 HI series
Category	Switch
Switch Type	Managed
Layer	Layer 3
Power over Ethernet (PoE)	Available on some models
Fans	Hot-swappable fans
Management	CLI, Web GUI, SNMP, RMON, HP Intelligent Management Center
Routing Protocol	RIP, OSPF, BGP, IS-IS, Static Routing
Layer 3 Features	VRRP
Security Features	ACLs, IEEE 802.1X, RADIUS, TACACS+, SSH, SSL
Quality of Service (QoS)	DiffServ
Weight	Varies by model
Operating Temperature	0°C to 45°C
VLANs	4094
Operating Humidity	10% to 95% non-condensing

Summary

Ethernet Interface Commands

Common Ethernet Interface Commands

Describes basic configuration and display commands for Ethernet interfaces.

Layer 2 Ethernet Interface Commands

Covers Layer 2 specific configurations like storm control and bridging.

MAC Address Table Commands

Ethernet Link Aggregation Commands

Spanning Tree Commands

VLAN Commands

Basic VLAN Commands

Port-Based VLAN Commands

Details commands for configuring port VLANs, including hybrid and trunk ports.

MAC-Based VLAN Commands

Explains how to configure VLANs based on MAC addresses and triggers.

IP Subnet-Based VLAN Commands

Covers VLAN assignment based on IP subnet or IP address.

Protocol-Based VLAN Commands

Private VLAN Commands

Voice VLAN Commands

LLDP Commands