HP FlexNetwork 5130 HI series User Manual

238
Use undo mvrp enable to restore the default.
Syntax
mvrp enable
undo mvrp enable
Default
MVRP is disabled on a port.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
For MVRP to take effect on a port, make sure the following requirements are met:
• MVRP is enabled both globally and on the port.
• The port is in up state.
• The link type of the port is trunk.
• The port is not a member of an aggregation group.
Examples
# Enable MVRP on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] mvrp global enable
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] mvrp enable
Related commands
display mvrp running-status
mvrp global enable
Use mvrp global enable to enable MVRP globally.
Use undo mvrp global enable to restore the default.
Syntax
mvrp global enable
undo mvrp global enable
Default
MVRP is disabled globally.
Views
System view
Predefined user roles
network-admin
Usage guidelines
To make MVRP take effect on a port, enable MVRP both on the port and globally.

HP FlexNetwork 5130 HI series Specifications

General

Brand	HP
Model	FlexNetwork 5130 HI series
Category	Switch
Language	English