271
Parameters
agent: Specifies an LLDP agent type. If no agent type is specified in Ethernet interface view, the
command enables LLDP polling and sets the polling interval for nearest bridge agents.
nearest-customer: Specifies nearest customer bridge agents.
nearest-nontpmr: Specifies nearest non-TPMR bridge agents.
interval: Sets the LLDP polling interval in the range of 1 to 30 seconds.
Examples
# Enable LLDP polling and set the polling interval to 30 seconds for the nearest customer bridge
agents on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp agent nearest-customer check-change-interval 30
lldp compliance admin-status cdp
Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP.
Use undo lldp compliance admin-status cdp to restore the default.
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
Default
CDP-compatible LLDP operates in disable mode.
Views
Layer 2 Ethernet interface view, management Ethernet interface view
Predefined user roles
network-admin
Parameters
disable: Specifies the disable mode. CDP-compatible LLDP in this mode cannot receive or transmit
CDP packets.
txrx: Specifies the TxRx mode. CDP-compatible LLDP in this mode can send and receive CDP
packets.
Usage guidelines
For your device to work with Cisco IP phones, you must perform the following tasks:
• Enable CDP-compatible LLDP globally.
• Configure CDP-compatible LLDP to operate in TxRx mode on the specified ports.
Examples
# Enable CDP-compatible LLDP globally and configure CDP-compatible LLDP to operate in TxRx
mode on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] lldp compliance cdp
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp compliance admin-status cdp txrx
To Next Page
Loading...
Need help?
General