129
reset stp
Use reset stp to clear spanning tree statistics. The spanning tree statistics include the numbers of
TCN BPDUs, configuration BPDUs, RST BPDUs, and MST BPDUs that are sent and received
through the specified ports.
Syntax
reset stp [ interface interface-list ]
Views
User view
Predefined user roles
network-admin
Parameters
interface interface-list: Specifies a space-separated list of up to 10 interface items. Each item
specifies an interface or a range of interfaces in the form of interface-type interface-number 1 [ to
interface-type interface-number 2 ]. The interface number for interface-number 2 must be equal to or
greater than the interface number for interface-number 1. If you don't specify this option, this
command clears the spanning tree-related statistics information on all ports.
Examples
# Clear the spanning tree statistics on ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.
<Sysname> reset stp interface gigabitethernet 1/0/1 to gigabitethernet 1/0/3
Related commands
display stp
revision-level
Use revision-level to configure the MSTP revision level.
Use undo revision-level to restore the default MSTP revision level.
Syntax
revision-level level
undo revision-level
Default
The MSTP revision level is 0.
Views
MST region view
Predefined user roles
network-admin
Parameters
level: Specifies an MSTP revision level in the range of 0 to 65535.
Usage guidelines
The MSTP revision level, the MST region name, and the VLAN-to-instance mapping table of a device
determine the device's MST region.
To Next Page
Loading...
Need help?
General