286
Service loopback group commands
display service-loopback group
Use display service-loopback group to display information about service loopback groups.
Syntax
display service-loopback group [ number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
number: Specifies a service loopback group ID. The value range for the number argument is 1 to
1024. If you do not specify a service loopback group, this command displays information about all
service loopback groups.
Examples
# Display information about service loopback group 5.
<Sysname> display service-loopback group 5
Service Group ID: 5 Service Type: Tunnel
Member:
GigabitEthernet1/0/1
GigabitEthernet1/0/2
Table 62 Command output
Field Description
Service Group ID Service loopback group ID.
Service Type
Service type of the service loopback group:
• Multicast-tunnel—Supports multicast tunnel traffic.
• Tunnel—Supports unicast tunnel traffic.
• Multiport—Supports multiport ARP traffic.
Member Member ports of the service loopback group.
port service-loopback group
Use port service-loopback group to assign a port to a service loopback group.
Use undo port service-loopback group to remove a port from a service loopback group.
Syntax
port service-loopback group number
undo port service-loopback group
To Next Page
Loading...
Need help?
General