HP FlexNetwork 5130 HI series User Manual

136
When the setting is configured in Layer 2 aggregate interface view, it takes effect only on the
aggregate interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after
the port leaves the aggregation group.
Examples
# In MSTP mode, disable the spanning tree feature on port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo stp enable
Related commands
• stp global enable
• stp mode
• stp vlan enable
stp global config-digest-snooping
Use stp global config-digest-snooping to enable Digest Snooping globally.
Use undo stp global config-digest-snooping to disable Digest Snooping globally.
Syntax
stp global config-digest-snooping
undo stp global config-digest-snooping
Default
Digest Snooping is disabled globally.
Views
System view
Predefined user roles
network-admin
Usage guidelines
Enable this feature both globally and on ports connected to other vendors' devices. To minimize
impact, enable the feature on all associated ports before you enable it globally.
Examples
# Enable Digest Snooping on GigabitEthernet 1/0/1 and then globally.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp config-digest-snooping
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] stp global config-digest-snooping
Related commands
• display stp
• stp config-digest-snooping

HP FlexNetwork 5130 HI series Specifications

General

Brand	HP
Model	FlexNetwork 5130 HI series
Category	Switch
Language	English