35
forward the traffic. To bring up the interface, use the undo shutdown command or disable the storm
control function.
Examples
# Configure GigabitEthernet 1/0/1 to block the traffic detected crossing the upper storm control
threshold.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] storm-constrain control block
Related commands
• storm-constrain
• storm-constrain control
storm-constrain enable log
Use storm-constrain enable log to enable an Ethernet interface to log storm control threshold
events.
Use undo storm-constrain enable log to disable log sending.
Syntax
storm-constrain enable log
undo storm-constrain enable log
Default
An interface generates logs when monitored traffic exceeds the upper threshold or falls below the
lower threshold.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Examples
# Enable GigabitEthernet 1/0/1 to generate logs when it detects storm control threshold events.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] storm-constrain enable log
storm-constrain enable trap
Use storm-constrain enable trap to enable an Ethernet interface to send storm control threshold
event traps.
Use undo storm-constrain enable trap to disable trap sending.
Syntax
storm-constrain enable trap
undo storm-constrain enable trap
Default
An interface sends out traps when monitored traffic exceeds the upper threshold or falls below the
lower threshold.
To Next Page
Loading...
Need help?
General