EasyManuals Logo
Home>HP>Switch>FlexNetwork 5130 HI series

HP FlexNetwork 5130 HI series User Manual

HP FlexNetwork 5130 HI series
306 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
28
storm-constrain command. Do not configure the storm constrain command and the
broadcast-suppression command at the same time. Otherwise, the traffic suppression result is not
determined.
When you configure the suppression threshold in kbps, the actual suppression threshold might be
different from the configured one as follows:
• If the configured value is smaller than 64, the value of 64 takes effect.
• If the configured value is greater than 64 but not an integer multiple of 64, the integer multiple of
64 that is greater than and closest to the configured value takes effect.
To determine the suppression threshold that takes effect, see the prompts on the device.
Examples
# Set the broadcast suppression threshold to 10000 kbps on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] broadcast-suppression kbps 10000
Related commands
• multicast-suppression
• unicast-suppression
display storm-constrain
Use display storm-constrain to display storm control settings and statistics.
Syntax
display storm-constrain [ broadcast | known-unicast | multicast | unicast ] [ interface
interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
broadcast: Displays broadcast storm control settings and statistics.
known-unicast: Displays known unicast storm control settings and statistics. This keyword is
available in Release 1121 and later.
multicast: Displays multicast storm control settings and statistics.
unicast: Displays unknown unicast storm control settings and statistics.
interface interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If you do not specify any keywords, this command displays all storm control settings on all storm
control-enabled interfaces.
Examples
# Display the storm control settings on all storm control-enabled ports.
<Sysname> display storm-constrain
Abbreviation: BC - broadcast; MC - multicast; UC – unicast

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP FlexNetwork 5130 HI series and is the answer not in the manual?

HP FlexNetwork 5130 HI series Specifications

General IconGeneral
BrandHP
ModelFlexNetwork 5130 HI series
CategorySwitch
LanguageEnglish

Related product manuals