102
Syntax
link-aggregation port-priority port-priority
undo link-aggregation port-priority
Default
The port priority of an interface is 32768.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
port-priority: Specifies the port priority in the range of 0 to 65535. The smaller the value, the higher
the port priority.
Examples
# Set the port priority to 64 for Layer 2 Ethernet interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] link-aggregation port-priority 64
Related commands
lacp system-priority
link-aggregation selected-port maximum
Use link-aggregation selected-port maximum to set the maximum number of Selected ports
allowed in an aggregation group.
Use undo link-aggregation selected-port maximum to restore the default.
Syntax
link-aggregation selected-port maximum number
undo link-aggregation selected-port maximum
Default
The maximum number of Selected ports for an aggregation group is 32.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
number: Specifies the maximum number of Selected ports allowed in an aggregation group. The
value range for this argument is 1 to 32.
Usage guidelines
Executing this command might cause some of the Selected ports in an aggregation group to become
Unselected ports.
The maximum number of Selected ports allowed in the aggregation groups must be the same for the
local and peer ends.
To Next Page
Loading...
Need help?
General