277
undo lldp max-credit
Default
The token bucket size for sending LLDP frames is 5.
Views
System view
Predefined user roles
network-admin
Parameters
credit-value: Specifies the token bucket size for sending LLDP frames, in the range of 1 to 100.
Examples
# Set the token bucket size for sending LLDP frames to 10.
<Sysname> system-view
[Sysname] lldp max-credit 10
lldp mode
Use lldp mode to configure LLDP to operate in service bridge mode.
Use undo lldp mode to restore the default.
Syntax
lldp mode service-bridge
undo lldp mode
Default
LLDP operates in customer bridge mode.
Views
System view
Predefined user roles
network-admin
Parameters
service-bridge: Specifies the service bridge mode.
Usage guidelines
The LLDP agent types supported by LLDP depend on the LLDP bridge mode:
• Service bridge mode—LLDP supports nearest bridge agents and nearest non-TPMR bridge
agents. LLDP processes the LLDP frames with destination MAC addresses for these agents
and transparently transmits the LLDP frames with other destination MAC addresses in the
VLAN.
• Customer bridge mode—LLDP supports nearest bridge agents, nearest non-TPMR bridge
agents, and nearest customer bridge agents. LLDP processes the LLDP frames with
destination MAC addresses for these agents and transparently transmits the LLDP frames with
other destination MAC addresses in the VLAN.
The bridge mode configuration takes effect only when LLDP is enabled globally. If LLDP is disabled
globally, LLDP can only operate in customer bridge mode.
To Next Page
Loading...
Need help?
General