HP FlexNetwork 5130 HI series User Manual (English)

To Next Page

To Previous Page

179

Usage guidelines

You can configure a nonexistent VLAN as the PVID of a hybrid port. When you delete the PVID of a

hybrid port by using the undo vlan command, the PVID setting of the port does not change.

For correct packet transmission, configure the same PVID for a local hybrid port and its peer.

To enable a hybrid port to transmit packets from its PVID, you must assign the hybrid port to the PVID

by using the port hybrid vlan command.

• The configuration made in Layer 2 Ethernet interface view applies only to the port.

• The configuration made in Layer 2 aggregate interface view applies to the aggregate interface

and its aggregation member ports.

{ If the system fails to apply the configuration to the aggregate interface, it stops applying the

configuration to aggregation member ports.

{ If the system fails to apply the configuration to an aggregation member port, it skips the port

and moves to the next member port.

Examples

# Configure VLAN 100 as the PVID of the hybrid port GigabitEthernet 1/0/1, and assign

GigabitEthernet 1/0/1 to VLAN 100 as an untagged member.

<Sysname> system-view

[Sysname] vlan 100

[Sysname-vlan100] quit

[Sysname] interface gigabitethernet 1/0/1

[Sysname-GigabitEthernet1/0/1] port link-type hybrid

[Sysname-GigabitEthernet1/0/1] port hybrid pvid vlan 100

[Sysname-GigabitEthernet1/0/1] port hybrid vlan 100 untagged

Related commands

• port hybrid vlan

• port link-type

port hybrid vlan

Use port hybrid vlan to assign a hybrid port to the specified VLANs.

Use undo port hybrid vlan to remove a hybrid port from the specified VLANs.

Syntax

port hybrid vlan vlan-id-list { tagged | untagged }

undo port hybrid vlan vlan-id-list

Default

A hybrid port is an untagged member of the VLAN to which the port belongs when its link type is

access.

Views

Layer 2 Ethernet interface view, Layer 2 aggregate interface view

Predefined user roles

network-admin

Parameters

vlan-id-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN ID

or a range of VLAN IDs in the form of vlan-id1 to vlan-id2. The value range for VLAN IDs is 1 to 4094.

Need help?

Do you have a question about the HP FlexNetwork 5130 HI series and is the answer not in the manual?

HP FlexNetwork 5130 HI series Specifications

General

Model	HP FlexNetwork 5130 HI series
Category	Switch
Switch Type	Managed
Layer	Layer 3
Power over Ethernet (PoE)	Available on some models
Fans	Hot-swappable fans
Management	CLI, Web GUI, SNMP, RMON, HP Intelligent Management Center
Routing Protocol	RIP, OSPF, BGP, IS-IS, Static Routing
Layer 3 Features	VRRP
Security Features	ACLs, IEEE 802.1X, RADIUS, TACACS+, SSH, SSL
Quality of Service (QoS)	DiffServ
Weight	Varies by model
Operating Temperature	0°C to 45°C
VLANs	4094
Operating Humidity	10% to 95% non-condensing