HP FlexNetwork 5130 HI series User Manual

233
display mvrp statistics
Use display mvrp statistics to display MVRP statistics.
Syntax
display mvrp statistics [ interface interface-list ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-list: Specifies a range of Ethernet interfaces in the form of interface-type
interface-number [ to interface-type interface-number ]. The interface-type interface-number
argument represents the interface type and interface number. If you do not specify this option, the
command displays MVRP statistics of all MVRP-enabled ports.
Usage guidelines
If MVRP is disabled on the specified ports, this command does not provide any output.
Examples
# Display MVRP statistics of all ports.
<Sysname> display mvrp statistics
----[GigabitEthernet1/0/1]----
Failed Registrations : 1
Last PDU Origin : 000f-e200-0010
Frames Received : 201
New Event Received : 0
JoinIn Event Received : 1167
In Event Received : 0
JoinMt Event Received : 22387
Mt Event Received : 31
Leave Event Received : 210
LeaveAll Event Received : 63
Frames Transmitted : 120
New Event Transmitted : 0
JoinIn Event Transmitted : 311
In Event Transmitted : 0
JoinMt Event Transmitted : 873
Mt Event Transmitted : 11065
Leave Event Transmitted : 167
LeaveAll Event Transmitted : 4
Frames Discarded : 0
----[GigabitEthernet1/0/2]----
Failed Registrations : 0
Last PDU Origin : 0000-0000-0000

HP FlexNetwork 5130 HI series Specifications

General

Model	HP FlexNetwork 5130 HI series
Category	Switch
Switch Type	Managed
Layer	Layer 3
Power over Ethernet (PoE)	Available on some models
Fans	Hot-swappable fans
Management	CLI, Web GUI, SNMP, RMON, HP Intelligent Management Center
Routing Protocol	RIP, OSPF, BGP, IS-IS, Static Routing
Layer 3 Features	VRRP
Security Features	ACLs, IEEE 802.1X, RADIUS, TACACS+, SSH, SSL
Quality of Service (QoS)	DiffServ
Weight	Varies by model
Operating Temperature	0°C to 45°C
VLANs	4094
Operating Humidity	10% to 95% non-condensing

Summary

Ethernet Interface Commands

Common Ethernet Interface Commands

Describes basic configuration and display commands for Ethernet interfaces.

Layer 2 Ethernet Interface Commands

Covers Layer 2 specific configurations like storm control and bridging.

MAC Address Table Commands

Ethernet Link Aggregation Commands

Spanning Tree Commands

VLAN Commands

Basic VLAN Commands

Port-Based VLAN Commands

Details commands for configuring port VLANs, including hybrid and trunk ports.

MAC-Based VLAN Commands

Explains how to configure VLANs based on MAC addresses and triggers.

IP Subnet-Based VLAN Commands

Covers VLAN assignment based on IP subnet or IP address.

Protocol-Based VLAN Commands

Private VLAN Commands

Voice VLAN Commands

LLDP Commands