98
Examples
# Specify 1023 (3FF in hexadecimal format) as the per-flow load sharing algorithm seed.
<Sysname> system-view
[Sysname] link-aggregation global load-sharing seed 3FF
Related commands
• display link-aggregation load-sharing mode
• link-aggregation global load-sharing algorithm
• link-aggregation global load-sharing mode
• link-aggregation load-sharing mode
link-aggregation ignore vlan
Use link-aggregation ignore vlan to configure a Layer 2 aggregate interface to ignore the specified
VLANs.
Use undo link-aggregation ignore vlan to restore the default.
Syntax
link-aggregation ignore vlan vlan-id-list
undo link-aggregation ignore vlan vlan-id-list
Default
A Layer 2 aggregate interface does not ignore any VLANs.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
vlan-id-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN ID
or a range of VLAN IDs in the form of vlan-id1 to vlan-id2. The value range for VLAN IDs is 1 to 4094.
The value for vlan-id2 must be equal to or greater than the value for vlan-id1.
Usage guidelines
With this command configured, a Layer 2 aggregate interface ignores the permitted VLAN and VLAN
tagging mode configuration of the specified VLANs when choosing Selected ports.
Examples
# Configure Layer 2 aggregate interface bridge-aggregation 1 to ignore VLAN 50.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation ignore vlan 50
link-aggregation lacp traffic-redirect-notification enable
Use link-aggregation lacp traffic-redirect-notification enable to enable link-aggregation traffic
redirection.
Use undo link-aggregation lacp traffic-redirect-notification enable to disable link-aggregation
traffic redirection.
To Next Page
Loading...
Need help?
General