HP FlexNetwork 5130 HI series User Manual

206
Field Description
Untagged ports Untagged members of the VLAN.
Related commands
• private-vlan (VLAN view)
• private-vlan primary
port private-vlan host
Use port private-vlan host to configure a port as a host port.
Use undo port private-vlan to restore the default.
Syntax
port private-vlan host
undo port private-vlan
Default
A port is not a host port.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
If the port has been assigned to a secondary VLAN, the command assigns the port to the primary
VLAN associated with the secondary VLAN. Also, the following events occur:
• For an access port, the device performs the following tasks:
{ Changes the port link type to hybrid.
{ Configures the secondary VLAN as the PVID.
{ Assigns the port to the primary VLAN as an untagged member.
• For a trunk port, the device does not change the port link type or PVID.
• For a hybrid port, the device does not change the port link type or PVID.
{ If the hybrid port has been a tagged or untagged member of the primary VLAN, this member
attribute remains in the primary VLAN.
{ If the hybrid port does not allow the primary VLAN, the device assigns the port to the primary
VLAN as an untagged member.
The undo port private-vlan command does not change the VLAN attributes (allowed VLANs, port
link type, and PVID) of the port.
You can assign the port to a secondary VLAN before or after you execute the port private-vlan host
command.
The port private-vlan host command is mutually exclusive with the port private-vlan trunk
promiscuous and port private-vlan trunk secondary commands.
Examples
In this example, VLAN 20 is a secondary VLAN associated with primary VLAN 2.
# Configure GigabitEthernet 1/0/1 as a host port, and then verify the configuration.
<Sysname> system-view

HP FlexNetwork 5130 HI series Specifications

General

Model	HP FlexNetwork 5130 HI series
Category	Switch
Switch Type	Managed
Layer	Layer 3
Power over Ethernet (PoE)	Available on some models
Fans	Hot-swappable fans
Management	CLI, Web GUI, SNMP, RMON, HP Intelligent Management Center
Routing Protocol	RIP, OSPF, BGP, IS-IS, Static Routing
Layer 3 Features	VRRP
Security Features	ACLs, IEEE 802.1X, RADIUS, TACACS+, SSH, SSL
Quality of Service (QoS)	DiffServ
Weight	Varies by model
Operating Temperature	0°C to 45°C
VLANs	4094
Operating Humidity	10% to 95% non-condensing

Summary

Ethernet Interface Commands

Common Ethernet Interface Commands

Describes basic configuration and display commands for Ethernet interfaces.

Layer 2 Ethernet Interface Commands

Covers Layer 2 specific configurations like storm control and bridging.

MAC Address Table Commands

Ethernet Link Aggregation Commands

Spanning Tree Commands

VLAN Commands

Basic VLAN Commands

Port-Based VLAN Commands

Details commands for configuring port VLANs, including hybrid and trunk ports.

MAC-Based VLAN Commands

Explains how to configure VLANs based on MAC addresses and triggers.

IP Subnet-Based VLAN Commands

Covers VLAN assignment based on IP subnet or IP address.

Protocol-Based VLAN Commands

Private VLAN Commands

Voice VLAN Commands

LLDP Commands