HP FlexNetwork 5130 HI series User Manual

107
Port isolation commands
display port-isolate group
Use display port-isolate group to display port isolation group information.
Syntax
display port-isolate group [ group-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group-number: Specifies an isolation group by its number in the range of 1 to 8.
Examples
# Display all isolation groups.
<Sysname> display port-isolate group
Port isolation group information:
Group ID: 2
Group members:
GigabitEthernet1/0/1
Group ID: 5
Group members:
GigabitEthernet1/0/2
GigabitEthernet1/0/4
# Display information about isolation group 2.
<Sysname> display port-isolate group 2
Port isolation group information:
Group ID: 2
Group members:
GigabitEthernet1/0/1
Table 23 Command output
Field Description
Group ID Isolation group number.
Group members
Isolated ports in the isolation group. If the isolation group
contains no isolated ports, this field displays
No ports
.
Related commands
port-isolate enable

HP FlexNetwork 5130 HI series Specifications

General

Model	HP FlexNetwork 5130 HI series
Category	Switch
Switch Type	Managed
Layer	Layer 3
Power over Ethernet (PoE)	Available on some models
Fans	Hot-swappable fans
Management	CLI, Web GUI, SNMP, RMON, HP Intelligent Management Center
Routing Protocol	RIP, OSPF, BGP, IS-IS, Static Routing
Layer 3 Features	VRRP
Security Features	ACLs, IEEE 802.1X, RADIUS, TACACS+, SSH, SSL
Quality of Service (QoS)	DiffServ
Weight	Varies by model
Operating Temperature	0°C to 45°C
VLANs	4094
Operating Humidity	10% to 95% non-condensing

Summary

Ethernet Interface Commands

Common Ethernet Interface Commands

Describes basic configuration and display commands for Ethernet interfaces.

Layer 2 Ethernet Interface Commands

Covers Layer 2 specific configurations like storm control and bridging.

MAC Address Table Commands

Ethernet Link Aggregation Commands

Spanning Tree Commands

VLAN Commands

Basic VLAN Commands

Port-Based VLAN Commands

Details commands for configuring port VLANs, including hybrid and trunk ports.

MAC-Based VLAN Commands

Explains how to configure VLANs based on MAC addresses and triggers.

IP Subnet-Based VLAN Commands

Covers VLAN assignment based on IP subnet or IP address.

Protocol-Based VLAN Commands

Private VLAN Commands

Voice VLAN Commands

LLDP Commands